
840/900 double-layer tile press
Parameters of 840/900 double-layer tile press: Dimensions: 5700mm× 1500mm×1500mm Forming method: roll forming (pre-compression forming) Number of forming rows: 10 rows of V900 rolls pre-pressed, 11 rows of V840 rolls pre-pressed Feed widt...
Parameters of 840/900 double-layer tile press:
Dimensions: 5700mm× 1500mm×1500mm
Forming method: roll forming (pre-compression forming)
Number of forming rows: 10 rows of V900 rolls pre-pressed, 11 rows of V840 rolls pre-pressed
Feed width: 1000mm
Thickness of rolling plate: "0.6mm
Equipment shaft diameter: Φ70mm
Main engine power: 3KW
Rolling speed: 10m-12m/min
Machine weight: about 3000kg
Pumping station motor: 3KW
Equipment frame: 300H steel
Cutter Material: Cr12 (Chrome 12)
Equipment transmission: sprockets, chains
The large frame of the equipment is all welded with 250# I-beam
Thickness of the middle plate: 14mm
Fully automatic computerized cut-to-length cutting system
The components of the 840/900 double-layer tile compactor include: the whole machine, PLC computer control system, hydraulic pump station system, automatic post-shearing system Equipment features: The color steel plate equipment adopts high-level automatic control software to achieve production information management. The automatic control system of the whole unit adopts a highly integrated network, which makes the performance of the automation system more superior. The double-layer tile compactor also has the advantages of operation, maintenance, maintenance, mechanical debugging, and easy mold replacement.
840/900 double-layer tile compactor commissioning method:
Put the four corners of the front and back lines of the tile press from the top of the frame to the upper end of the shaft, and then from the first row to. In the back row, find a line to straighten, check whether the lower axis is in a straight line, and adjust the left and right sides of the lower axis to level.
Then put the first row of tile presses and. Find the center in the back row, then tighten the lock nuts on both sides, pull a straight line in front of and behind the center of the middle wheel, and adjust the gap between the upper and lower shafts, and then adjust the machine along the straight line.
The debugging method of the post-tile pressing plate deviation, such as the plate running to the right, padding the left corner (feeding rack), or falling the right bottom flat (the first few axes run off the bottom of the first few axes, and the upper shaft falls with the bottom shaft.